Private IP Address Ranges Explained (10.x, 172.16.x, 192.168.x)

By · · Updated · 1 min read

If you've ever wondered why your router at home has exactly the same address as your friend's, this is why. Back in 1996, a standard called RFC 1918 set aside three blocks of IPv4 addresses for private networks. Nobody owns them, they're never routed across the public internet, and any home or office can reuse them as often as it likes.

Block Range CIDR Where you'll see it
24-bit 10.0.0.0 to 10.255.255.255 10.0.0.0/8 ISP gateways (e.g. 10.0.0.1) and large companies
20-bit 172.16.0.0 to 172.31.255.255 172.16.0.0/12 Corporate networks, Docker, iPhone hotspots (172.20.10.1)
16-bit 192.168.0.0 to 192.168.255.255 192.168.0.0/16 Most home routers (192.168.0.1, 192.168.1.1)

Home routers almost always pick the smallest block, 192.168.x.x, simply because a house never needs millions of addresses. Businesses with thousands of devices tend to use 10.x.x.x so they have room to grow.

A few other special addresses

You'll occasionally run into these too:

  • 127.0.0.0/8: loopback, meaning your own device talking to itself.
  • 169.254.0.0/16: link-local. If a device shows one of these, it asked the router for an address and got no answer.
  • 100.64.0.0/10: carrier-grade NAT. Mobile networks and some fibre providers use it, and it's the reason port forwarding sometimes doesn't work.

How private and public addresses fit together

Every device in your house has its own private address, but they all share one public address on the internet. The router keeps track of who asked for what, using NAT. You can see both sides with What Is My IP and What Is My Local IP, and plan your own subnets with the CIDR subnet calculator.