192.168.1.0
Private IP address · Network address · Network 192.168.1.0/24
192.168.1.0 is a private (RFC 1918) IP address that only works inside a local network, never on the internet. On a standard home network (192.168.1.0/24, mask 255.255.255.0) it is normally assigned to a device such as a phone, PC or printer, and the router is usually at 192.168.1.1.
- Type
- Private (RFC 1918)
- Role
- Network address
- Router (gateway)
- 192.168.1.1
192.168.1.0 is a private IPv4 address from the 192.168.0.0/16 block reserved for local networks. On a standard home network (192.168.1.0/24, subnet mask 255.255.255.0) it is the network address of a /24 subnet. It identifies the network itself and is not assigned to a device on a standard 255.255.255.0 network.
The 192.168.1.x network is the default LAN of TP-Link, Netgear, Linksys, D-Link, ASUS, Huawei routers, so on those networks 192.168.1.0 is normally a connected device.
About the 192.168.1.x network
192.168.1.0/24 is the most widely used home network range in the world. You will typically find it on:
- Netgear routers
- Linksys routers
- older ASUS routers
- ZTE and Huawei ISP modems
- Cisco and DrayTek routers
- Verizon Fios and Spectrum routers
Whether 192.168.1.0 is handed out automatically depends on the router's default DHCP pool:
| Router / system | Default DHCP pool | 192.168.1.0 |
|---|---|---|
| Netgear routers | 192.168.1.2: .254 | ➖ Outside pool (good for a static IP) |
| Linksys routers | 192.168.1.100: .149 | ➖ Outside pool (good for a static IP) |
| older ASUS routers | 192.168.1.2: .254 | ➖ Outside pool (good for a static IP) |
How to find which device is using 192.168.1.0
- Check your router. Log in at 192.168.1.1 (or 192.168.1.254) and open Connected devices, DHCP clients or Attached devices. Find 192.168.1.0 in the list to see the device name and MAC address.
- Use the ARP table. On a computer on the same network, run
ping 192.168.1.0followed byarp -a. Look up the MAC address shown with our MAC Address Lookup to identify the manufacturer. - Try the web interface. Printers, cameras, NAS drives and access points often have a page at
http://192.168.1.0.
192.168.1.0 not reachable?
- Make sure your device is on the same
192.168.1.xnetwork: runipconfigand compare the first three numbers. - Run
ping 192.168.1.0. "Request timed out" means the device is off, asleep, or blocks ping with its firewall. - An "IP address conflict" means two devices use 192.168.1.0: restart both, or create a DHCP reservation.
- Disconnect from any VPN: it can route local traffic away from your network.
Useful commands for 192.168.1.0
Copy these to test or configure the device at 192.168.1.0 from a computer on the same network:
Windows
ping 192.168.1.0 tracert 192.168.1.0 arp -a | findstr 192.168.1.0 nslookup 192.168.1.0
macOS
ping -c 4 192.168.1.0 traceroute 192.168.1.0 arp -a | grep "(192.168.1.0)"
Linux
ping -c 4 192.168.1.0 ip neigh show 192.168.1.0
192.168.1.0 technical details
| IP address | 192.168.1.0 |
|---|---|
| Address type | Private (RFC 1918): 192.168.0.0/16, 16-bit block |
| Role on a /24 network | Network address |
| Position in 192.168.1.0/24 | — |
| Network / broadcast | 192.168.1.0/24 / 192.168.1.255 |
| Usable host range | 192.168.1.1 to 192.168.1.254 |
| Integer (decimal) | 3232235776 |
| Hexadecimal | C0.A8.01.00 (0xC0A80100) |
| Octal | 0300.0250.01.00 |
| Binary | 11000000.10101000.00000001.00000000 |
| IPv4-mapped IPv6 | ::ffff:192.168.1.0 · ::ffff:c0a8:100 |
| 6to4 prefix | 2002:c0a8:0100::/48 |
| Reverse DNS (PTR) name | 0.1.168.192.in-addr.arpa |
192.168.1.0 in every subnet size
The same address belongs to a different network depending on the subnet mask. This table shows where 192.168.1.0 falls for each common prefix length:
| Prefix | Mask | Network | Broadcast | 192.168.1.0 is |
|---|---|---|---|---|
| /16 | 255.255.0.0 | 192.168.0.0 | 192.168.255.255 | host #256 of 65534 |
| /20 | 255.255.240.0 | 192.168.0.0 | 192.168.15.255 | host #256 of 4094 |
| /24 | 255.255.255.0 | 192.168.1.0 | 192.168.1.255 | network address |
| /25 | 255.255.255.128 | 192.168.1.0 | 192.168.1.127 | network address |
| /26 | 255.255.255.192 | 192.168.1.0 | 192.168.1.63 | network address |
| /27 | 255.255.255.224 | 192.168.1.0 | 192.168.1.31 | network address |
| /28 | 255.255.255.240 | 192.168.1.0 | 192.168.1.15 | network address |
| /29 | 255.255.255.248 | 192.168.1.0 | 192.168.1.7 | network address |
| /30 | 255.255.255.252 | 192.168.1.0 | 192.168.1.3 | network address |
Plan other ranges with the subnet calculator.
Common misspellings of 192.168.1.0
These won't open anything: IP addresses contain only digits and dots. Type 192.168.1.0 exactly:
192.168.1.0: FAQ
Is 192.168.1.0 a private IP address?
Yes. 192.168.1.0 is in the 192.168.0.0/16 private range (RFC 1918). It only works inside a local network and cannot be reached directly from the internet.
What device uses 192.168.1.0?
It depends on your network. Log in to your router at 192.168.1.1 and check the DHCP client / connected-devices list, or run "arp -a" on a computer on the same network.
Is 192.168.1.0 assigned automatically by DHCP?
On Netgear routers, Linksys routers, older ASUS routers it is outside the default pool (.2–.254, .100–.149, .2–.254), which makes it a good choice for a static IP.
Can I log in to 192.168.1.0?
Only if the device at 192.168.1.0 has a web interface (for example a printer, camera or NAS). Normally you log in to the router at 192.168.1.1 instead.
Can I assign 192.168.1.0 to a device?
Not on a normal /24 (255.255.255.0) network: it is the network address. Use an address between 192.168.1.2 and 192.168.1.253.
Who uses the 192.168.1.x network?
192.168.1.0/24 is the most widely used home network range in the world. It is used by Netgear routers, Linksys routers, older ASUS routers, ZTE and Huawei ISP modems, Cisco and DrayTek routers, Verizon Fios and Spectrum routers.
What is 192.168.1.0 in binary and hexadecimal?
In binary 192.168.1.0 is 11000000.10101000.00000001.00000000; in hexadecimal it is C0.A8.01.00 (0xC0A80100); as a single decimal number it is 3232235776.