Billion BiPAC 7800 Login

Default IP address, username & password · Updated

Quick answer

The Billion BiPAC 7800 uses 192.168.1.254 as its default login address. Connect to the router's Wi-Fi or plug in a cable, open http://192.168.1.254 in a browser and sign in with username "admin" and password "admin". If those details were changed and you can't remember them, a factory reset (holding the reset button) restores the defaults.

The Billion BiPAC 7800 uses 192.168.1.254 as its default admin address. Open http://192.168.1.254 while connected to the router and sign in with the username admin and password admin.

How to log in to the Billion BiPAC 7800

  1. Connect to the Billion BiPAC 7800. Connect your device to the Billion BiPAC 7800 by Wi-Fi or Ethernet cable.
  2. Open the admin page. Type http://192.168.1.254 into your browser's address bar.
  3. Log in. Use username admin and password admin.
  4. Secure the router. Change the admin password and the Wi-Fi password, then save.

Change the BiPAC 7800 Wi-Fi name and password

  1. Log in to the Billion BiPAC 7800 admin panel.
  2. Open Wireless (or Wi-Fi Settings).
  3. Edit the network name (SSID) and set a strong WPA2/WPA3 password.
  4. Save, then reconnect your devices with the new password.

Factory reset the Billion BiPAC 7800

Hold the reset button for 10 to 15 seconds while the BiPAC 7800 is on. When the lights flash, release it and wait about two minutes. The login returns to admin / admin at 192.168.1.254.

Default network settings

LAN IP (gateway)192.168.1.254
Subnet mask255.255.255.0
DHCP range (typical)192.168.1.1 to 192.168.1.254
BrandBillion (Taiwan)

Billion BiPAC 7800 FAQ

What is the Billion BiPAC 7800 default IP address?

The Billion BiPAC 7800 uses 192.168.1.254 by default.

What is the Billion BiPAC 7800 default password?

Out of the box, the Billion BiPAC 7800 uses username admin with password admin. If those no longer work, the login was changed and a factory reset brings them back.

How do I factory reset the Billion BiPAC 7800?

With the BiPAC 7800 powered on, hold its Reset button for 10 to 15 seconds until the lights change, then let it restart (about two minutes). Afterwards, reconnect and open http://192.168.1.254 to sign in with the defaults and set it up again.