AT&T NVG589 Login
Default IP address, username & password · Updated
The AT&T NVG589 uses 192.168.1.254 as its default login address. Connect to the router's Wi-Fi or plug in a cable, open http://192.168.1.254 in a browser and sign in with username blank (leave it empty) and password Device Access Code on the label. If those details were changed and you can't remember them, a factory reset (holding the reset button) restores the defaults.
- IP address
- 192.168.1.254
- Username
(blank)- Password
(Device Access Code on the label)
The AT&T NVG589 uses 192.168.1.254 as its default admin address. Open http://192.168.1.254 while connected to the router and sign in with the username (blank) and password (Device Access Code on the label).
AT&T gateways ask for the Device Access Code printed on the side label when you change settings.
How to log in to the AT&T NVG589
- Connect to the AT&T NVG589. Connect your device to the AT&T NVG589 by Wi-Fi or Ethernet cable.
- Open the admin page. Type http://192.168.1.254 into your browser's address bar.
- Log in. Use username (blank) and password (Device Access Code on the label).
- Secure the router. Change the admin password and the Wi-Fi password, then save.
Change the NVG589 Wi-Fi name and password
- Log in to the AT&T NVG589 admin panel.
- Open Wireless (or Wi-Fi Settings).
- Edit the network name (SSID) and set a strong WPA2/WPA3 password.
- Save, then reconnect your devices with the new password.
Factory reset the AT&T NVG589
Hold the reset button for 10 to 15 seconds while the NVG589 is on. When the lights flash, release it and wait about two minutes. The login returns to (blank) / (Device Access Code on the label) at 192.168.1.254.
Default network settings
| LAN IP (gateway) | 192.168.1.254 |
|---|---|
| Subnet mask | 255.255.255.0 |
| DHCP range (typical) | 192.168.1.1 to 192.168.1.254 |
| Brand | AT&T (USA) |
AT&T NVG589 FAQ
What is the AT&T NVG589 default IP address?
The AT&T NVG589 uses 192.168.1.254 by default.
What is the AT&T NVG589 default password?
Out of the box, the AT&T NVG589 uses username (blank) with password (Device Access Code on the label). If those no longer work, the login was changed and a factory reset brings them back.
How do I factory reset the AT&T NVG589?
With the NVG589 powered on, hold its Reset button for 10 to 15 seconds until the lights change, then let it restart (about two minutes). Afterwards, reconnect and open http://192.168.1.254 to sign in with the defaults and set it up again.